Tera 60 Rear Axles

Tera 60 rear axle with disc brakes and TJ coil spring brackets

Foothill Tera 60 rear axles are the ultimate axles for offroad use. They feature high strength, high ground clearance and a high pinion. The housing is a high alloy casting with large webbing, a cast cover for additional strength, and a machined surface with drilled and tapped mounting holes for the custom suspension builder. The high clearance affords the same clearance as a Dana 44 axle, with no compromise in strength. The high pinion reduces driveshaft angles and is a benefit to short wheelbase or highly lifted rig. Configurations are available for any vehicle. Our rear axles feature:

  • Spicer ring & pinion sets (ratio of your choice)
  • Timken bearings
  • Spicer small parts (seals, yoke, hardware)
  • Dutchman 35 spline alloy axle shafts
  • 5, 6 or 8 lug wheel pattern
  • 11″ x 2″ drum brakes
  • U bolt style yoke
  • Differential of choice (open, limited slip, or locker)

Rear axles are built to your specifications. Upon placement of order, a build sheet will be completed that shows the width, pinion angle, spring location and lift, lug pattern, gear ratio choice, brake choice, and locker choice.

  • Drum brakes up to 13″ diameter
  • Disc brake kit
  • Jeep TJ coil spring bracket kit
  • Yoke for 1330 or 1350 series U joint
  • Full float axle shafts (8 lug wheel pattern only)

Our axles include a 24 month/24,000 mile warranty on workmanship and warranties on all aftermarket products are honored.


%1$s uses cookies. For more detailed information about these cookies please see our privacy policy. Please accept to continue or block all non-essential cookies.

I accept cookies from this site.